- Description
-
Details
1. Easy to install.
2. Built-in drilling template.
3. Dual DC & DCC available:
a. Dispatch mode (DCC stationary decoder) and
b. Switch mode. (Toggle switch or Push button switch options).
4. Remote programming technique: Improved user-friendly fully adjustable “hand throttle”.(control board)
5. Adjustable servo speed from slowest 1 to fastest 9. (factory default: middle 5)
6. Adjustable servo horn angles.
7. Dual LED displays in the hand throttle.
8. Improved servo silent technique for analog servos.
9. The virtual center line for easy trouble free mounting.
10. Minimal structural interference---the servo and its mounting linkage are compact in size.
11. More mounting possibilities---traditional, off-center or horizontal rotary installation. The servo can be installed either below the road bed or next to the turnout.
12. Adjustable servo speed and position through the programming features in the SmartSwitchTM control board to give you ultimate control for pressing the point rails against the stock rails.
13. Each control board can control up to four turnouts.
14. Can simultaneously control one or up to four servos by using one toggle switch or push button.
15. Remember the turnout positions when power is off.
16. Provides various settings for indication and signal light.
17. Low current draw. 9V is the minimum requirement for the input power supply.
18. DCC friendly--- the SmartSwitchTM stationary decoder supports a full range of DCC accessory addresses (1-2048) and offers simple mainline address programming.
19. The decoder also supports route control features from major DCC manufacturers.
20. The SmartFrogTM has easy DCC friendly power route wiring. The precise polarity switch when both the point rails are not in contact with the stock rails allows for zero chance of short circuit.
21. The SmartSwitchTM gives you the ultimate flexibility.
Dimension
SmartSwitch control board --110mm x 60mm x 18mm (4.33” x 2.36” x 0.7”)
Hand programming board—42mm x 70mm x 19mm (1.65” x 2.75” x 0.748” )
Extension wire 39.37” / 100cm
Contents
1. (1) SmartSwitchTM main control board
2. (1) SmartSwitchTM hand control board
3. (4) SmartFrogTM board
4. (1) Stationary decoder
5. (4) 9g servo
6. (4) Servo bracket
7. (8) Φ3 x 10mm Wood Screw (For securing servo bracket)
8. (16) Φ2.6 x 15mm Wood Screw (For securing SmartSwitchTM, SmartFrogTM)
9. (4) Φ3 x 20mm Pan Head Machine Screw
10.(4) Hex nut
11.(4) Φ0.6 x 100mm(3.9”) control wire
12.(2) 500mm(19.5”) long extension wire
13.(2) 1000mm(39.37”) long extension wire
14.(5) SPST 2 pin toggle switch
15.(16) 5mm plastic spacer (For securing SmartSwitchTM, SmartFrogTM ,Stationary decoder)
- Reviews
-